这种测试方法包括涂层对基材的粘附程度(结合强度)或涂层在正常于表面的张力下的内聚强度的测定。该测试包括涂覆基材夹具的一个面,将该涂层粘接到加载夹具的表面,并使该涂层和夹具的组装承受垂直于涂层平面的拉伸载荷。它特别适用于测试通过热喷涂应用的涂层,其定义包括燃烧火焰、等离子弧、两线弧、高速氧气燃料和用于喷涂给料的爆轰过程,这些给料可能是线材、棒材或粉末的形式。热喷涂材料包括陶瓷,如金属氧化物或碳化物,以及金属。在某些情况下,涂层是由不同的喷涂材料形成的,例如将氧化物层喷涂到喷涂的金属键合层上。基板一般是金属,但也可以是陶瓷,如氧化物或石墨。通常这种测试方法在环境温度下进行。较高的温度测试受到需要合适的粘合剂粘合剂的限制。对于某些基础研究,建议使用极低(低温)温度。此测试方法仅限于测试可应用于厚度大于0.015英寸的热喷涂涂层。 (0.38 mm). The limitation is imposed because an adhesive bonding agent is used in the test. Those bonding agents established so far for this method tend to penetrate thermal spray coatings and may invalidate results unless the coatings are thick enough to prevent penetration through the coating. Further development may establish that thin layers of certain types of especially dense coatings may be tested satisfactorily. Alternatively, new adhesive bonding agents that would allow reduction of the minimum thickness limitation may become available.